detent
1. The operability has been improved by incorporating a good-feeling detent mechanism.
4) 通过整合手感良好的齿形机构而提高了操作性。
2. Low detent torque to holding torque ratios for MAE "HN" and "HS" models further contribute smooth operation and the fine positioning capability required for microstepping.
MAE "HN"和"HS"模块的低定位转矩到保持力矩的比率,进一步提供用于微步进要求的平滑操作和良好的定位操作。
3. Associated with the turn knob are two microswitches, which are closed when the knob is in the detent position.
与旋钮连接的是两个微型开关,它们在旋钮处于制动位置时是闭合的。
4. centralized detent
中立位置定位卡销
5. safety detent
保险卡销 安全卡爪
6. This paper analyse the test circuitry of assembling unit of motor and detent when it is tested about the braking time, and provides a corresponding conclusion.
分析了电动机制动器机组制动试验时的测试电路,并对测试结果进行了简明扼要的分析,给出了相应的结论。
7. Keywords detent;defect;numerical simulation;
制动器;缺陷;数值模拟;
8. A detent is one notch of the mouse wheel.
制动器是鼠标轮的一个凹口。
9. detent plate
制动器板
10. detent valve
制动器锁紧阀
11. detent knob
制动手柄
12. detent plate stop
制动架 制动片 停臂
13. holding detent
制动爪
14. detent plug
制动销 止销
15. That's exactly the detent feature we talked about which are standard in any VW and Audi cars.
唔系有啲车系无段车门咩?开到咩角度就会定左,斜路都唔怕架喎!
16. Therefore, the movement of every reasonable to permanent magnet so that they superimposed the smallest detent force, that was through the magnetic pole migration methods to reduce the detent force.
因此,合理地移动每对永磁体,使它们叠加的磁阻力合力最小,即通过磁极偏移的方法来减小磁阻力。
17. 34.Regions and units directly benefiting from flood storage and detention areas should bear obligations of compensation and aid to flood storage and detent ion areas as required by the state.
因蓄滞洪区而直接受益的地区和单位,应当对蓄滞洪区承担国家规定的补偿、救助义务。
18. It shows that the results by two methods agree well.Moreover, the single pair and adjacent rotor poles torque characteristics also with the detent torque characteristic are studied.
在此基础上,分别研究了电机的单对极转矩特性、相邻转子磁极之间相互作用以及定位转矩特性。
19. detent escapement
天文钟擒纵机构
20. It must also be taken into account that, in spite of the minimum detent torque, the motor reaches a maximum holding torque.
它也必须顾及的是,尽管最低定位转矩,电机达到最大转矩举行。
21. detent mechanism
定位器
22. locating detent
定位爪 定位掣子 定位锁销
23. detent pin
定位销
24. detent position
封闭位置
25. Set the tracking force dial to the zero detent position.
将针压钮调到零的位置。
26. On the regulation of regulation valve with intelligent valve detent mechanism
带智能阀门定位器的调节阀的调校问题及处理
27. The construction and processing (including the EDM for detent) of net shape forming die for detent gear have been emphatically studied.
带爪齿轮目前被广泛应用于各种摩托车的档位机构。
28. Construction winches, hoist winches, draw winches and detent winches
建筑卷扬机、提升卷扬机、牵引卷扬机、制动卷扬机
29. spring detent
弹簧爪
30. Currently, a value of 120 is the standard for one detent.
当前,120是一个制动器的标准值。
31. A slotted design is also available on request when detent torque is needed, for applications such as Damper Control.
当用到定位转矩做阻尼控制时,有槽设计也可以达到低震动。
32. tracking control detent position
循迹控制止动位置
33. setback detent
惯性销
34. We need concentric (stacked, dual shaft) potentiometers. 100k linear with center detent (click).
我们需要同心(堆叠,双轴)电位。100,000线性与中心棘爪(点击)。
35. detent eccentric
拉档偏心销
36. flat jewel cylindrical hole for detent
拉档有孔平钻
37. detent bridle
拉档限动杆
38. detent catch mechanism
挡弹机构
39. detent roller
掣轮
40. This paper discusses a key technology of collaboration in the virtual enterprise through the realization of a magnetism particle detent′s computer aided design system based on the WWW.
本文提出了一种把 www和计算机辅助设计相结合的磁粉制动器设计系统 ,介绍了一种异地协同设计环境中远程资源的调用过程
41. pivoted detent escapement
枢轴式天文钟擒纵机构
42. pivoted detent
枢轴式擒纵机构 枢制动器 装有枢轴的棘爪 枢轴掣子
43. The Snipped Analysis of Resisting Shear Pin on Detent Catch of a Rocket Launcher
某火箭炮闭锁挡弹器抗剪销剪断分析
44. detent spring
棘爪簧
45. Research on test of the detent force in permanent magnet linear synchronous motor
永磁同步直线电机定位力测试实验研究
46. CALCULATION OF DETENT TORQUE OF PERMANENT MAGNET OSCILLATION MOTOR BY FINITE ELEMENT METHOD
永磁式摆动电动机定位转矩的有限元计算
47. Analyses of the air-gap magnetic field and detent force of permanent magnet linear synchronous motor
永磁直线同步电动机气隙磁场及磁阻力分析
48. Detent force analysis and optimization of permanent magnet linear synchronous motor
永磁直线同步电机的磁阻力分析及其优化
49. DETENT FORCE ANALYSIS AND REDUCTION OF PMLSM
永磁直线同步电机的磁阻力分析及其最小化研究
50. 2.Slag collector: wet slag discharge is made by hydraulic ratchet wheel, detent, worm wheel or worm from both sides.
清灰机构:采用液压驱动棘轮、棘爪装置或蜗轮蜗杆装置湿式双侧除灰。
51. Slag discharge mechanism: wet slag discharge is made from both sides with hydraulic drive of ratchet wheel and detent.
清灰机构:采用液压驱动棘轮、棘爪装置,湿式双侧除灰。
52. detent plate cover
盖板
53. magnetic detent
磁制动器
54. magnetic - powder - detent
磁粉制动器
55. detent force
磁阻力
56. the slot-teeth componentof detent force
磁阻力齿槽分量
57. spin detent
离心保险销
58. the operability has been improved by incorporating a good-feeling detent mechanism;
设计紧凑,可靠性高;结构强度高;
59. The detent torque has especially adverse effects in micro step mode [1].
该定位转矩具有特别的不利影响,在微步模式[ 1 ] 。
60. The detent torque of motors with few phases is greater than that of motors with more phases.
该定位转矩马达与数期大于电机与更多的阶段。
61. This controller divided the regular step size into many steps between the detent positions, and provided different stepping speeds.
该控制器不仅可将稳定平衡点之间的通常步距进行多级细分,还可提供不同的步进速度。
62. The harmonic portions of the electric conductance of the order 2 * m primarily cause the detent torque (m = number of phases).
谐波部分的电导该命令的2 *米,主要的原因定位转矩(米=几个阶段) 。
63. Turn the left temperature control knob clockwise one detent.
谢谢!汽车本科,机械硕士。200万字翻译经验。
64. detent torque
起动转矩
65. jumping second detent
跳秒针拉档
66. This provides for a known start-up position for the motor by forcing a position between two detent positions.
通过将位置设定为两个制动位置之一,就可以知道电动机的启动位置。
67. spring detent escapement
锁簧式天文钟擒纵机构
68. detent catch
锁闩
69. Besides the property of the asynchronous motor,the taper asynchronous motor can daff the detent easily,because magnetic force is generated when stator three-phrase windings connect to the electricity.
锥形异步电动机除具有一般异步电动机性能外,还因定子三相绕组接通电源时产生轴向磁拉力,可顺利推开制动器,从而使锥形异步电动机正常运行。
70. Aldrin: OK. Engine stop. ACA out of Detent.
阿尔德林:OK..引擎停止。ACA制动脱离。
71. Aldrin:OK.Engine stop.ACA out of Detent.
阿尔德林:OK.引擎停止。ACA制动脱离。
72. detent notch
驻销卡口
73. detent finger
齿止弹片