recoat

recoat

1. 1.If wrench has not been used or has been in storage for some time, operate it severol times at a low torque setting which permits special interal lubricant to recoat internal working parts.

1、如果扳手没有使用过或存储了相当长的一段时间后，请先在低转矩设置下使用几次，以便专用的内部润滑重新润滑扳手的内部零件。

2. recoat time

再涂时间

3. recoat adhesion

再涂附着力

4. Additional, old building is brushed in recoat when, must consider the facial expression of original furniture, curtain, carpet.

另外，旧房子在重新涂刷时，必须考虑原有家具、窗帘、地毯的颜色。

5. May be specified in another film thickness than indicated depending on purpose of use and area. This will alter spreading rate, drying time and recoat interval. Normal range dry : 80-125 mm.

可按照使用目的或区域修改漆膜厚度，但这会相应改变涂布率、干燥时间和重涂间隔。干膜厚度的正常范围为80-125微米。

6. Later, liteweide comes through using pure and bright color aggrandizement structure, make its are not added completely conceal, the primary colors on recoat.

后来，里特维德通过使用单纯明亮的色彩来强化结构，使其完全不加掩饰，重新涂上原色。

7. The coating of same color also had better besmear brush end.If face of construction ending back wall needs to repair, be about to brush whole metope recoat.

在水泥干透之后，用专用的水平尺确定整个地面的平整度，然后再进行下一步的施工。

8. If maximum recoat interval is exceeded, roughening of the surface is necessary to ensure intercoat adhesion.

如超过最大重涂间隔，应将先涂漆面磨粗以确保漆膜间的附着力。

9. If maximum recoat is exceed, roughening of the surface is necessary to ensure intercoat adhesion.

如超过最大重涂间隔，应磨粗表面，以保证附着力。

10. If maximum recoat interval is exceeded, roughen the film surface to ensure the adhesion between layers.

如超过最大重涂间隔，须磨粗表面，以确保漆膜间的附着力。

11. And every are blown should shave needs recoat cream.

而且每刮一遍都应该重新涂一次剃须膏。

12. COLOUR: Light Green,APPLICATION: Spatula,MIXING RATIO: (in volume) Base/Hardener 2/1,COVERAGE: 1m2/lt,DRYING TIME: sandable after 16-24 hours, Dry to recoat time: min. 12 hours max: 24 hours

颜色:淡绿,施工工具:抹刀,混合比例:(体积比)主漆/固化剂2/1,覆盖率:1平方/升,干燥时间:16小时后可用砂磨,重涂时间:最小12小时最多24小时