torquing

torquing

1. "Hopefully, soon my ankle will allow me to move better laterally and with torquing and everything," he said.

“很幸运，我的脚踝好些了，横向移动的时候不会觉得疼了。”加索尔表示。

2. The special support and the single torquer structure is used to open a new technical way for increasing the gyro torquing rate.

其采用的特殊支承及单力矩器结构,为提高陀螺加矩速率开阔了新的技术途径。

3. Application of anterior root torquing auxiliary arch

前牙转矩辅弓的应用

4. Undesirable magnetic coupling can occur as a result of an error in the alignment of the torquing system.

力矩系统校直存在的误差能产生不希望有的磁性耦合。

5. 6. Found inseam and outseam is serious torquing causing serious unbalance outseam &inseam fold on(left &right).

发现内外骴骨因止口左右不对称导致严重扭脾.

6. Whenever flange bolts are tightened the torquing sequence must be done in a star pattern (See Figure 5).

在紧固法兰螺栓时，必须按照星形模式顺序（参阅图5）来进行螺栓紧固。

7. Come up on ball of lead foot to avoid torquing knee.

在领引脚的球上发生避免转力矩膝。

8. Keywords DTG with the larger angular velocity,larger torquing angular velocity,torque rebalance loop,decoupling control, flexure support, attitude algorithm;

大角速率动力调谐陀螺仪;最大施矩角速率;力矩再平衡回路;解祸控制;挠性支承;姿态解算;

9. Attitude Control Torquing Device

姿态控制扭矩装置

10. Installation and torquing should be done with the valve in full open position.

安装工作和紧固工作都应该在阀门处于全开位置时进行。

11. Proper torquing avoids elastic separation of the mating parts under load and resists gradual loosening over time.

扭矩正确,就能防止配合部件在负荷作用下出现弹性分离,并防止部件在长期运转过程中逐渐松动。

12. torquing auxiliary

扭转辅助线

13. Torquing Tie Rod End Attaching Nut

拧紧转向拉杆端接合螺帽

14. The paper proposes an active damping control scheme for hemispheric torquing with equatorial marking line on rotor.

提出一种采用转子赤道刻线,利用赤道光电传感器的输出来控制阻尼力矩方向的半球施矩主动阻尼控制方案。

15. torquing unit

攻螺丝的机械化工具

16. CAUTION: UNNECESSARY OVER TORQUING WILL DAMAGE THE FLANGE.

注意：不必要的过大力矩会损坏法兰。

17. 16. The torquing current is measured and related to drift rate by prior calibration data.

测出产生力矩的电流，然后根据事先校正的数据来算出飘移率。

18. Because valve assemblies are often stored for long periods before installation, the above considerations are also applicable. This means torquing before start-up is required if prolonged storage occurs.

由于通常阀门总成在安装前都会储存很长一段时期,上述的考虑也都适用。这意味着在长期储存后需要足够的开启之前的扭矩。

19. Maintain knee and toe alignment to prevent knee torquing.

维持膝和脚趾对准阻止膝转力矩。

20. torquing key

转矩器

21. torquing of nuts

转矩拉紧螺母

22. torquing auxiliary arch

转矩辅弓

23. Using 2.5 newtons of thrust applied at either the asteroid's north or south pole, the task would require a couple months of steady torquing.

这个工作需要在小行星的北或南极使用2.5牛顿的推力，数个月持续地扭转。